Bad idea/good idea?
Postig a couple pics so you have a good visual. I am getting ready to put water int he 240 and have a last minute hesitation. I have 3/4" super dense gym floor-mat between the tank and the plywood. I couple of reasons behind this - 1) eliminate any unevenness that would stress the glass and be potential failure points. ( I should note the stand was made in a commercial steel fabrication facility) 2) it was free and I had it on hand.
Here are the pics
Steel stand | full view | close up
[/URL][/IMG]
One more full shot of aquarium on the stand
What would you do?
Postig a couple pics so you have a good visual. I am getting ready to put water int he 240 and have a last minute hesitation. I have 3/4" super dense gym floor-mat between the tank and the plywood. I couple of reasons behind this - 1) eliminate any unevenness that would stress the glass and be potential failure points. ( I should note the stand was made in a commercial steel fabrication facility) 2) it was free and I had it on hand.
Here are the pics
Steel stand | full view | close up
One more full shot of aquarium on the stand
What would you do?
Last edited: