While I was out driftwood hunting today I stopped at the petstore that was in the town I was in. The had a bottle of seachem prime so I got one its just the smaller 100ml bottle its all they had. I've never used this before because the stores around me don't carry it. I was reading the back of it and it says 1 capful which is 5ml will be enough for 200 L (50 gallons). Then it says each cap thread is approx 1ml. Now I use a 4 gallon bucket when I do water changes and add the conditioner to each bucket. So I would need some were under half a line cause one like would be 10 gallons. So how would I measure that out really can't do it in the cap. I know theres gotta be people on here that use it that add it to each bucket like I do.
Calling all Seachem Prime users
- Thread starter erk419
- Start date
i use the same conditioner, and do it in a 4 gallon bucket too
i just fill the lid ever so little, and if anything put more than is really necessary for 4 gallons, but youd rather waste than not put enough
i just fill the lid ever so little, and if anything put more than is really necessary for 4 gallons, but youd rather waste than not put enough
When you add to the tank instead of adding to each bucket you have to dose for the whole tank. So in my case I would have to dose for 150 gallons instead of 30 gallons
I just found the answer I'm going to get an eydropper 20 drops equals 1ml so if I add 2 drops to each gallon so 8 drops to a 4 gallon bucket it will be a perfect dose actually prob a tad more because I don't fill it to the rim
No I put the prime in before the water then put the bucket under the tub faucet it does a great job mixing it up.
