My first large tank with a my first cycling. So I have a lot of questions
My setup.
Tank is 72x24x30
Running two ehiem 2217's.
2 fluval 300w heaters
Substrate is Eco complete for cichlids about 160lbs.
River rocks and 1 piece of drift wood
Plants are amazon sword, java fern, Java moss, and Anubis
Used API Master test kit
Ph 8.0
Ammonia 0
I finally found the right ammonia to start the cycling with (that was not easy in my area but found Ace janitorial)
I know my filters are not enough for a tank of this size but budget is limited. Eventually I will be adding an eheim 2262 to help out.
I am just checking to make sure I am on the right track thus far. I have been checking for ammonia about the same time every day. Thus far I have been greeting a reading of .05 after that I add ammonia to bring the level back up to about 3-4ppm. Am I doing it correctly? Also just checked nitrites and have a reading o about 2.0ppm. Just checking to make sure I am on the right path. As I understand it I need to wait for the ammonia to go to zero within 24hrs before I start water changes correct?
Any advice/input is greatly appreciated.
Thanks for the help with this
My setup.
Tank is 72x24x30
Running two ehiem 2217's.
2 fluval 300w heaters
Substrate is Eco complete for cichlids about 160lbs.
River rocks and 1 piece of drift wood
Plants are amazon sword, java fern, Java moss, and Anubis
Used API Master test kit
Ph 8.0
Ammonia 0
I finally found the right ammonia to start the cycling with (that was not easy in my area but found Ace janitorial)
I know my filters are not enough for a tank of this size but budget is limited. Eventually I will be adding an eheim 2262 to help out.
I am just checking to make sure I am on the right track thus far. I have been checking for ammonia about the same time every day. Thus far I have been greeting a reading of .05 after that I add ammonia to bring the level back up to about 3-4ppm. Am I doing it correctly? Also just checked nitrites and have a reading o about 2.0ppm. Just checking to make sure I am on the right path. As I understand it I need to wait for the ammonia to go to zero within 24hrs before I start water changes correct?
Any advice/input is greatly appreciated.
Thanks for the help with this