How bad are bubbles in acrylic seams?

Basically done building my 480, but there are a few spots where small bubbles and some short lines in the acrylic seam formed. The thickest is maybe 1/8" in one small spot up the side. The tank is 8x4x2 high and the acrylic is 1/2". I think I know why the lines and bubbles formed. I hand sanded the edges to prep them and they werent perfectly flush when I finished. Do you think I will be okay? I was going to use weld on 16 all around the bottom edge just to add a bit more re-enforcement to the seams. Also how long should I wait to test fill? A week?

Basically I'm asking how detrimental are a few bubbles to the integrity of a tank.

Thanks in advance.

weld-on 4. I got a couple perfect seams but I got a thin line in a couple seams. Some are hair thin but one is like 1/8" at its widest point.

It was definitely my edge prepping that was the problem. It was almost impossible to get it perfect with a sanding block. (I thought every one was perfect, but I guess not)

Oh I know its impossible to redo. I had to rip off the front panel to redo it after I realized the acrylic wasn't touching in certain spots. That was like 20 mins after I applied it and it was a massive pain to get off. It says 72hrs for 80 percent strength.

So do you think it would be okay to start adding water after 72 hours? I think I will start with a couple inches just to make sure all the corners are sealed and then add a couple inches every 6 hours or so.

In my house. lol I dont have the luxury of a garage and its about minus 20 degrees Celsius outside