Basically done building my 480, but there are a few spots where small bubbles and some short lines in the acrylic seam formed. The thickest is maybe 1/8" in one small spot up the side. The tank is 8x4x2 high and the acrylic is 1/2". I think I know why the lines and bubbles formed. I hand sanded the edges to prep them and they werent perfectly flush when I finished. Do you think I will be okay? I was going to use weld on 16 all around the bottom edge just to add a bit more re-enforcement to the seams. Also how long should I wait to test fill? A week?
Basically I'm asking how detrimental are a few bubbles to the integrity of a tank.
Thanks in advance.
Basically I'm asking how detrimental are a few bubbles to the integrity of a tank.
Thanks in advance.