180 Gallon Stand and Canopy Build

Thought I would document this to help any others out there that are debating on building a stand of their own also. I've never done this before and thought I would give it a try and see how it goes.

It's for my 6x2x2 180 gallon tank and going to build it a little different than some i've seen on here after doing some extensive research on builds. I went and got a Mitar Saw, Wood Glue, Deck Screws 2 1/2, triangle, measuring tape, and a pen (already had lol) and dove right in.

I have decided to make the stand 36" tall, because I do like to be able to look at my tank standing up somewhat and not have to bend over to see it. I do realize that there is a catch in that it's harder to reach the bottom, but at 6'2" tall, I can reach pretty far inside And before anyone says something, I have to go back to the store tomorrow and get another 2x4 for the support in the middle, thought I had enough :/

Here is some pictures to get it started:

Rayshot1;4902487; said:

looks good! and good job on the disclaimer for the middle brace!

Click to expand...

Yea, I knew that would be very noticeable Going to try and get another piece this afternoon or tomorrow and get the frame done. Then move onto the frame and molding.

Thought I would add a few more pictures to update progress. I put the bottom plywood on a little different than most do. I put on the beams on the inside of the stand that are basically there to drill the uprights high enough from the bottom to allow for a flat 2x4 and 1/2 plywood. It's hard to explain, but hopefully the picture will explain it, this is much easier than trying to cut notches out of the sides of the plywood to slide it down inside or having to cut it in half...etc... I have one flat piece that is supported by 4 flat 2x4's and it will hold my sump(or sumps) and filters with ease.

Going to get the frame wood today hopefully and start getting it on this week or weekend, will update with pics as I progress