Hello everyone. I had an idea and just wanted to run it by you guys and get some thoughts on it. The plan is to build a 330 gallon indoor pond out of 3 pieces of plywood, some 2x4s, and a pond liner. I was going to take a 4x8 sheet of plywood as the bottom, and cut some 94 and 48 inch sides 18 inches tall, screw it all together, slap some 2x4s around the top and bottom for support, and stick a pond liner in it. Similar to this video
http://www.youtube.com/watch?v=-15IlqMtk44
But obviously wider longer and not as tall. Anyone forsee problems? What should I change? I figure if anything mine will be easier than his without the height.
http://www.youtube.com/watch?v=-15IlqMtk44
But obviously wider longer and not as tall. Anyone forsee problems? What should I change? I figure if anything mine will be easier than his without the height.
