Hey guys! Hope everyone's doing well. Here's a quick feeding video of the 560. All has been running well minus an inline heater malfunctioning and blowing at the seams and some serious water clean up and replumbing.
I'm pretty sure I'm gonna panel the stand soon. It's 45" high and tanks 4' by 8' so I'm thinking home depot 1/2" 8x4 sheets shave 3" off long ways split in half for the two 45x48 sides then two more sheets shave 3" and that'll be the long sides. I was thinking nail gun on two, trying to figure out a way to maybe magnet other two on for easy removal for weekly maintenance. Any clever ideas to throw my way far as this paneling goes?
I'm pretty sure I'm gonna panel the stand soon. It's 45" high and tanks 4' by 8' so I'm thinking home depot 1/2" 8x4 sheets shave 3" off long ways split in half for the two 45x48 sides then two more sheets shave 3" and that'll be the long sides. I was thinking nail gun on two, trying to figure out a way to maybe magnet other two on for easy removal for weekly maintenance. Any clever ideas to throw my way far as this paneling goes?