Another Stand design question

[bleublaze55]

So don't make fun of my MS paint blueprint. I just wanted to get it in some sort of drawing.
I have come up with this very basic design to construct a tank stand for my 115gal that i am building this weekendish. The blue represents the plywood and the red represents the 2x4. Of course i would use glue and nails for all joints. But im worried about the diagonal physics. I think i need some sort of horizantal bracing. But i need to make sure i have enough room in the back left corner for the plumbing. So with that said. im looking to those experts for some advice. I should add that there will be plywood in front and on the sides. This is just the skeleton part.

 

[Maduro]

not enough info in your illustration......just search this section, in 15 minutes you'll have 10 options.

Look at the frame used on 144g link below...its super basic.

 

[bleublaze55]

Im thinking the height of the stand will be around 40", the length is 60", the depth is 18". The tank is 60x18x24. I think a better inner frame might need to be accomplished before i continue through.

 

[Pharaoh]

Based on the drawing, you will definitely need more support in many areas. I like to encourage people to use this design.