Aquarium lid question

[Crashdawg]

Hello all. I have a strange question. I have a 125 tank ( I think)
When I purchased it I got a sweet deal. $120.00 . But it has no kids so I am using light defusers and aquarium lid pieces off of my 75. My question is this. I have looked for the glass lids and all I can find for a 72 inch 125 is the three section set up. My tank only has one center brace so I need a two section set up. Any ideas? Thanks.. CD

 

[Dixon81]

What are the actual dimensions of your tank. I would confirm how many gallons it is then try to source the glass lids for that tank.

 

[jaws7777]

Sounds like its a marineland/perfecto.

Those lids can be found on amazon

 

[Crashdawg]

What are the actual dimensions of your tank. I would confirm how many gallons it is then try to source the glass lids for that tank.

72x18x22 (LxDxH)

 

[Dixon81]

Measure the actual openings and see if any of these will fit

http://www.drsfostersmith.com/product/prod_display.cfm?pcatid=3790

 

[Thomas18]

Go to your local hardware and get a sheet of double wall polycarbonate and cut that to size

 

[Crashdawg]

Go to your local hardware and get a sheet of double wall polycarbonate and cut that to size

yeah may be best

 

[Busterny]

You could also go to a local glass co. I just pick up 2 nice sizes pieces for a 75 and it cost less than $15. Cut them right on the spot in less than 10 minutes.

 

[Crashdawg]

You could also go to a local glass co. I just pick up 2 nice sizes pieces for a 75 and it cost less than $15. Cut them right on the spot in less than 10 minutes.

Thinking about doing this. Saves money