Alright I'm sure this topic has been covered already but couldn't see to find it. I basically want to know whats the best way to setup my filters and power head to make it remove waste the best. I currently had a Inlet on the far left of the tank that is about 2" above the sand. Then just to the right of the Inlet I have a outlet that is facing to the right. Then to the left of the tank I have a inlet that is about 2" Under the top of the water. And the outlet for this filter is in the corner on the left facing directly towards the front of the tank. And I also have a dual headed power head that is on the Right wall of the tank halfway up facing slightly down. Is there anything I could change or improve to make the waste get pushed to the filter inlet without being too much current for the fish?
