Hey guys, I am having a problem with my 220's bulkhead holes. 3 out of the 4 holes are 2.75 in in diameter, while one is 2 3/8 in. So the smaller one isn't a problem since it will fit a 1.5" bulk head perfectly, but the other three are just a tad over 1/4 in. too big for the 1.5" bulkhead. They are also 1/4 in. too small for a 2" bulkhead. If I set a 1.5" in one of the bigger holes and just let it sit on the bottom of the hole, it doesn't even cover the top of the hole, so you can see a pretty substantial amount of space exposed. So my question would it be best to just center a 1.5 inch bulkhead in all the holes, which would still be waterproof, its just not a tight fit. Or is there some way I can expand to other holes to fit a 2" bulkhead, preferably without redrilling them. Just to be clear if the 1.5" bulkheads are in there CENTERED in the hole there isn't empty space, but if it is touching one of the sides of the hole then there is a space. Thank you very much.
P.S. I didn't drill these holes
P.S. I didn't drill these holes
