Ok So I have a "Ghetto Pond" at the moment and I just had to move houses thankfully it was only 4 houses away but it being on the ground and everything it was a pain in the ass to move and took roughly 12 hours to move and setup. And I plan on going into the Air Force here in about 6 months so I need to make the pond much easier to move so I plan on a plywood pond of sorts sitting on a 2' base/stand with a bulkhead in the bottom for easy draining When I need to move and I'm basically looking for feed back on the design.
Dimensions are 6' x 6' inside about 6'9" outside if I remember right. Plywood will go up 23 inches and water will be 20" high roughly
Will Be covered with a pond liner that's what the 2x4s on top are for and why the plywood is under them. Will also be 3/4" plywood on the inside
Styro for extra insulation to cut down on heat costs.
Dimensions are 6' x 6' inside about 6'9" outside if I remember right. Plywood will go up 23 inches and water will be 20" high roughly
Will Be covered with a pond liner that's what the 2x4s on top are for and why the plywood is under them. Will also be 3/4" plywood on the inside
Styro for extra insulation to cut down on heat costs.
