Hi, I just have a question about glass cutting... how would I drill a hole in my glass tank if it is even possible? If not, how would I go about getting it done? Thanks.
Glass Cutting
- Thread starter Davey_8313
- Start date
Davey, Ive seen it documented before. Im more of an acrylic guy myself when it comes to fabrication but to my understanding the key was to go extremely slow and use very little downward pressure, I believe the guy used a diamond tip holesaw to make the cut.
Alright, thanks man. Acrylic is the stuff that you have to spray w/ water when you're drilling right, not glass?
