glass question, help mee

[easydoesit]

planning a DIY plywood tank w. dimensions of 38x38x24.
the 24 is the ground space, including the overflow filtration area in the back.
the front will look like a square.
how thick should my glass(34"x34") be?

 

[easydoesit]

im guessing half an inch? maybe?

 

[ilikewomen]

not worth it,it would cost to much to make it.just get someone to make it for you.or make it out of glass

 

[ilikewomen]

if you do, 1/2 in is a little on the low side for that height,use 3/4

 

[easydoesit]

I got a table that has the glass on top for cheap. Its gonna be here tomorrow. If it's not 1/2" thick, which i doubt it will be, ill just go to a glass place and get it cut since its most likely going to be tempered.
Unless the fact that its tempered makes a difference in how thick I need it?
The tank will be about 110 gallons without the overflow area.. and I doubt I could find a tank with those dimensions anywhere else, so I think it'd be worth it to make it. How much do you think it would cost as an estimation? I already figure that just the waterproofing cost(epoxy, silicone, fiberglass mat strips) will be about 100.

 

[easydoesit]

alrighty nvm, not gonna use it unless i can cut it for later tanks or a mini project im gonna start.