I am in the planning stages of getting all my tanks on a continuous drip but what I am really worried about is most of my tanks are glass and not sure how to go about drilling them for bulk heads , I have ran new water lines and ran lines going out side to an outdoor pond and I have the preformed pond drilled and it has lines that goes to my flower garden and to a couple trees so its going to be a sweet system once I can get the drilling figured out .
The tanks that I am needing to drill are a 360 gallon acrylic ( I know how to drill this one ), 2 - 220's glass , 75 gallon glass, 4 - 55 gallons Glass( thinking about replacing the 4 - 55's with 2 - 180's )
I was also wondering if anyone knew a place in st. louis that could drill them for me ?
Or would it be better to sell the tanks I have and then try to get acrylic tanks ?
The tanks that I am needing to drill are a 360 gallon acrylic ( I know how to drill this one ), 2 - 220's glass , 75 gallon glass, 4 - 55 gallons Glass( thinking about replacing the 4 - 55's with 2 - 180's )
I was also wondering if anyone knew a place in st. louis that could drill them for me ?
Or would it be better to sell the tanks I have and then try to get acrylic tanks ?
