Is this adequate for a 40g Breeder?
- Thread starter atmetoyer
- Start date
Are the brown studs in direct contact to the floor and to the bottom of the tank? If so, you're good to go.
Yeah that is the plan, but those shouldnt be holding any weight the black ones should be the ones bearing the weight, right?
I'm confused by your drawing, the side view shows the brown on the outside of the red, while the top/bottom view shows reds on the outside.
The brown is on the inside, I just put it over the top so I could show the full length of the brown piece visually.
Gotcha. I would run another "red" on the inside of the brown (parallel to the original red).......on both sides of the stand. Then you should be solid!