Trying to build a above ground pond and have two piece of plexiglass size 30" x70"x2" thick need to be square off and the other piece cut in half and square off . Also know a good pond paint for cement pond and a good glue for glueing the plexiglass to the block wall? Thanks for any help...
Know anybody that cut plexiglass in so cal?
- Thread starter redarro101
- Start date
Reptile88;4305209; said:
I agree with Reptile88 in both respects, just keep in mind though, there may be a service charge for them cutting and squaring up your material. I would probably use those two excellent suggestions as they are most likely to be set up to do the exacting work you need to have done.
Anywhere else like a cabinet shop which MIGHT HAVE the capability of cutting your material, may have a greater cost to you because the type of material you're wanting cut is not made of wood and they will not guarantee their work. They may not be set up for this type of material and your cuts may not be smooth and perfectly clean. Just keep in mind too, any cabinet shop may not guarantee complete success with what you're wanting to do. Any liability of having your material safe and sound during this process, will most likely be your sole responsibility. Just fish food for thought
. Good Luck.TAP plastics has stores all over check there web site for a location. Also glass shops usually have blades set up to cut plexi
If you have a circular saw just use a new carbide blade and a guide. Use the hose to keep it wet and cut away.
