Nano PVC overflow

[nfored]

So here is my micro over flow for my 10G Made with 1/2" PVC and 1/4 Tubing.

The flow rate is low due to the 1/4 tubing but its fast enough to handle the drip system. I made it like this so its easier to start the siphon if it breaks, plus it allows for the maximum flow rate for the smaller tubing, by not restricting the overflow housing, with a tube stuck down the center.

 

[Pharaoh]

Nice job. I finally get what you meant now that I see pics. LOL

 

[nfored]

I think that on a full size overflow of this style you can get the full flow rate, for the rated size tubing.