need help please

[burzumaske20]

Ok,I was doing a water change today and I noticed a tiny little leak,not where its squirting out,but if I fill the tank all the way pass the trimming part,it will start to little drops,so I took out some water to reduce it.Is there anything I can do to seal that part or can I seal the outside of the tank.Since I bought the tank used,it seemed like the previous owner did a good job on resealing 3 out of 4 sides on this 125 gallon tank.
thanks

 

[burzumaske20]

Also on another note its a glass tank.

 

[love The Jack Dempseys]

try to seal the inside and outside if possible and pics would help if its not to hard to get them.

 

[burzumaske20]

Well it maybe too hard to get the picture,cause its by the trimming part,but I will try to show you the exact location as much as possible

 

[burzumaske20]

see parts of water through there

that is where the little tiny leak happened was by the thick glass part,its basically in the upper part of the darker trim

Tiny drips came out from the right side,just two drops though

 

[love The Jack Dempseys]

Ohhh i was imagining something different lol idk but yea i would just say do the outside, good luck

 

[burzumaske20]

Do I have to drain the tank at all to do the outside or no?the leak started in the two inch thick glass on the inside though,but its just in the tiny upper corner area it seems where I can't see it.

 

[love The Jack Dempseys]

i dont think so but you could drain if you think you should, wait for somebody else's opinion too because im not an expert on resealing tanks and that kind of thing.

 

[burzumaske20]

Well,I don't notice anymore water going through,so I hope I don't have to drain the tank,just to reseal the outside part.

 

[burzumaske20]

Would anyone else know,if I have to drain the tank,just to seal the outside part or no?