i got some bad advice i believe and didn't like where things were headed on another forum site ....so now i'm here....not looking to go back to the other one.
i got 2 tanks i'm concerned with and would like some help with but if you don't have knowledge please don't post.
lets start off with the uncycled 29 gallon tall..... tanks has heater set at 82 it has an emperor 400 filter,sand substrate,minimal decor,
current readings from my api master test kit are as follows
ph-7.6
ammonia. 1ppm
nitrate and nitrite 0
nitrate and nitrite were the same before big water changes but the ammonia was around 5+ppm
the people on the other website suggested doing several 50% -75% water changes throughout the day..... this has brought my ph from 6.4 to 7.4 in one day...... thats bad right!!
also the tap water is 8.4 out of the faucet.
where am i at and what should i do or stop doing
i got 2 tanks i'm concerned with and would like some help with but if you don't have knowledge please don't post.
lets start off with the uncycled 29 gallon tall..... tanks has heater set at 82 it has an emperor 400 filter,sand substrate,minimal decor,
current readings from my api master test kit are as follows
ph-7.6
ammonia. 1ppm
nitrate and nitrite 0
nitrate and nitrite were the same before big water changes but the ammonia was around 5+ppm
the people on the other website suggested doing several 50% -75% water changes throughout the day..... this has brought my ph from 6.4 to 7.4 in one day...... thats bad right!!
also the tap water is 8.4 out of the faucet.
where am i at and what should i do or stop doing