Ok what am i doing wrong? It usually takes 30 min just to get my python to start sucking water. Well I mean it's sucking water or trying to. It gets so far up the tube but before it goes into that container it stops. It is hard to get it going. Once it gets going I have to leave it in 1 spot stuck in the gravel just so it keeps sucking water. I can't move it around to clean the gravel because the pressure just dies if I move it at all. It really sucks. What am I doing wrong?
Need help with pond python
- Thread starter fishnoob
- Start date
http://www.pythonproducts.com/p-uvac.html
that?
sorry,never seen one till now so im not much help.
did read this tho
""""Low flow rate for controlled cleaning. """
its not a fast worker but it should still work.
maybe return it say it dont work then go buy an out of water pump,
make your own gravel vac end,
and hook it up to the pump.
dont suck up your fish tho.lol
other then that im not much help
that?
sorry,never seen one till now so im not much help.
did read this tho
""""Low flow rate for controlled cleaning. """
its not a fast worker but it should still work.
maybe return it say it dont work then go buy an out of water pump,
make your own gravel vac end,
and hook it up to the pump.
dont suck up your fish tho.lol
other then that im not much help
yeah thats it lol. but okmidnight;1606707; said:http://www.pythonproducts.com/p-uvac.html
that?
sorry,never seen one till now so im not much help.
did read this tho
""""Low flow rate for controlled cleaning. """
its not a fast worker but it should still work.
maybe return it say it dont work then go buy an out of water pump,
make your own gravel vac end,
and hook it up to the pump.
dont suck up your fish tho.lol
other then that im not much help
and if its 4 feet,4 feet sounds like alot,im not sure if cutting some off would help or not.
"think before ya cut it tho cus im not sure if it will help or not"
"think before ya cut it tho cus im not sure if it will help or not"