New Rack setup

[NemoNemo]

Hi All,

this is going to be my third return into the hobby and i would like to start with rack this time.
I have found a good rack that may be a good candidate to be used, but did not find anyone who may have used it in the past or heard anything.

The rack is Whalen Industrial Rack- 76.875" x 24" x 72" (w x d x h)
-Welded end frames provide strength
-Each shelf holds 2,000 lbs. (evenly distributed)
-Protective powder-coated steel
-4 adjustable shelves with wire decks
-Link additional racks to create industrial-sized storage solution
-Single tool assembly

I'm going to put one 180 gal (72x24x24) on the middle level, two 65 gal (35x24x18) on the top level and the sump 110 Gal (60x24x18) on the lower level.
You help is much appreciated.

thanks.

 

[TheRealAndyCook]

The rack is measured on the outside correct? that means you have VERY little space to move things around, lifting two 65G tanks and making them fit that top row with only 1/2 an inch on either side...might be tricky...as long as you leave enough space between the shelf and the wall I don't see any major issues