pond liner help

[Jimbo_from_canada]

Ok I m thinking about making a pond out of an old deep freeze I m going to put a pond liner in it but what I m wondering is what’s the best way to do the corners I plan in putting something over the out side so I kind of want the inside to look good is there a way to fold it? Or cut it and some how seal it some how thanks for your help

 

[midnight]

dont cut
fold the corners like wrapping a present

 

[dannyboy]

yep definately don't cut it. Fold the corners like midnight suggested. Depending on what type of pond liner it is, there are specific tapes and glues you can get, that you could tape over/glue down the folded edges if you wanted. But the water pressure should hold it in place pretty well. DEFINATELY DONT CUT IT, it just makes life a whole lot harder

 

[black peter]

here is how i did it

 

[HoangLan]

Peter, what kind of glue do you use? Thanks.

 

[Dr Joe]

Will this be indoor or outdoor?

 

[portabuddy]

that looks like standard spray adgesive... contact sement...


Spray, let it flash, then after 1-2 min. apply. you could also probably use rubber cemt if you have it. since its a rubber liner that would work well...

 

[black peter]

Peter, what kind of glue do you use? Thanks.

I used spray adhesive from " 3M" that is called "rubber and vinyl 80" and it is at home depot.I sprayed it and then used brush to spread it evenly.you have to do both sides and wait one minute then connect them.