I have been thinking about how to seal my ply cheaply. I was thinking about sticking a thin layer of acrylic to the ply, but our local supplier is extortionate. I was wishing I could get some cheap placcy sheet, food grade just a few mm thick would do!!! Why is it sooo expensive...when a possible answer hit me...the bottle I am drinking from...its food grade PET, a recycleable thermoplastic!
That should do! So I cut the top off the bottle and the bottom, leaving a cylinder, then cut this in half. Flattened them out giving about 2 tiles @ 1 sq ft... This Rocks...
I have stuck them together using the gas hob as I dont have a hot air gun yet!!! Its difficult to do like that though as there is a very fine line between melt and burn!
Next pay check I'm getting a hotair gun and raiding the recycle point!!! Anyone tried this or any thoughts????
That should do! So I cut the top off the bottle and the bottom, leaving a cylinder, then cut this in half. Flattened them out giving about 2 tiles @ 1 sq ft... This Rocks...
I have stuck them together using the gas hob as I dont have a hot air gun yet!!! Its difficult to do like that though as there is a very fine line between melt and burn!Next pay check I'm getting a hotair gun and raiding the recycle point!!! Anyone tried this or any thoughts????
