Steel stand, attaching boards with magnets.

[markstrimaran]

Well it's warming up enouph. To work out side.
I have some 3/4" oak plywood for the project.
Looking for any advice on what not to do. I want it to be completely module.
Mostly so I can work on it randomly.
I will probably trim the painted metal. With formica.

 

[markstrimaran]

This is the old roll top computer stand. That my sump was on top of. 100% recycled, but then a free project. Makes the wife happy.

 

[markstrimaran]

This side is screwed to the aquarium stand. So it will not be wobbly, being 60" tall and 16" wide.


6 screws, holding it. The notches are so I can lift it over tabs, welded to the stand, which it fastens too.


Rough cut and fitted. It all has to come apart someday to get sanded, and stained a mahogany red.

 

[markstrimaran]

Good enouph, to hold a few things, the old peg holes, made putting the shelves in fast.
Ran out of daylight, to cut the top board.

 

[jsc]

Looks good! Double bonus by using the old desk!

 

[markstrimaran]

Table saw quit working, got a new one yesterday so progress will continue.
Might need some more 3/4" magnets.