Greetings all!
I have some very good bubble stones, but they have a VERTICAL stem vs a HORIZONTAL one. The issue is that I am putting a couple of them under decorations and that means that the airline is getting crimped. I know that there are plastic pieces for angles, but they are all male connectors - I have not (yet) found any female connectors.
I would like to be able to put four (4) angle connectors together so that the last one is horizontal to prevent crimping -
something like this:
=====
(bubble stone) || ||
++++++++++++++ ||
++++++++++++++ ||======
Any ideas? I suppose worst case would be that I have to have a small joining segment of tubing between each connector, but ideally, I'd like to avoid that.
Thanks!
--- DS
I have some very good bubble stones, but they have a VERTICAL stem vs a HORIZONTAL one. The issue is that I am putting a couple of them under decorations and that means that the airline is getting crimped. I know that there are plastic pieces for angles, but they are all male connectors - I have not (yet) found any female connectors.
I would like to be able to put four (4) angle connectors together so that the last one is horizontal to prevent crimping -
something like this:
=====
(bubble stone) || ||
++++++++++++++ ||
++++++++++++++ ||======
Any ideas? I suppose worst case would be that I have to have a small joining segment of tubing between each connector, but ideally, I'd like to avoid that.
Thanks!
--- DS
