If you have seen my other thread I'm building a tank stand with a plywood tank built into te base.
I'm after some help with the base that the top tank will stand on.
It's 50 inch long and supported 4 inches off each end .
the base for the tank is made from , 40x90 mm timber with piece of 20mm chipboard then 40mm of poly foam.
But the timber as twisted slightly , there is about a 1-2mm variation , do u think it will flatten out with the tank on it , a then te chipboard an poly be enough to even the pressure out?
Sent from my iPhone using MonsterAquariaNetwork app
I'm after some help with the base that the top tank will stand on.
It's 50 inch long and supported 4 inches off each end .
the base for the tank is made from , 40x90 mm timber with piece of 20mm chipboard then 40mm of poly foam.
But the timber as twisted slightly , there is about a 1-2mm variation , do u think it will flatten out with the tank on it , a then te chipboard an poly be enough to even the pressure out?
Sent from my iPhone using MonsterAquariaNetwork app
