THE 675 running but not done and fish

[HULON]

Ok guys so it's up and running have a few problems going on but when your hoocking up a new tank sometimes you do.... I have one pump a W lim Wave pump running my bottom returns acting as power heads 3000 gph running flawless check out how thr Lim pump is shoving the sand Nice i set it up that way to keep the poop moving not sitting on the bottom the returns are adjustable so obviosly i need to turn then up a touch so it's not shoving the sand.Also don't have the lighting hooked up yet it's going to be two twin tube 4ft t-5's 10000k daylight bulbs also i am only partialy done with scaping ..The other i bought used from another member a hammerhead was supposed to be working well right off another tank first off No gasket in th Impeller cover at all ...Second the seal is totally shot gushen gallons out the gut said just had the seal replaced last year No way Bro ...So i will try replacing the seal the shaft is rusted a bit so i'll see if a new seal helps if not in the garbage money lost and buy a new one i guess i should have in the first place ...Enough of my ventingHeres the tank picks and some fishies

 

[Mudslinger14]

Look nice, man.

 

[jcardona1]

zOMG it has watersss!!11

Looking good Hulon. I like the pile of the sand in the corner lol. So you're all done with the filtration and plumbing, and just need to add the other pump?

 

[acipenser22]

awesome

 

[gangster]

Good work Hulon! Im in love w/ that stand. The sand looks good as well. Cant wait to see it finished.

 

[HULON]

Look nice, man.

Thanks man ..

zOMG it has watersss!!11

Looking good Hulon. I like the pile of the sand in the corner lol. So you're all done with the filtration and plumbing, and just need to add the other pump?

LOL!!!! you like my pile of sand ..I am only partialy done with the scaping BroI had the other pump on but leaks badly i will try replacing the shaft seal if not the trash it goes and i have to spend another couple Dollers Thing that sucks also is each of these pumps has totally different thread sizes so if i can't fix the Hammerhead i will have to replumb the fitration part so the Lim pump will work on it then when i get a replacement or fix this one i will have to replumb yet again
Hoser you are the prince of wise ARSE but i love it

awesome

Thanks....

 

[West1]

Nice... Finally running
Q... why dont you put the Heater in the Sump??

 

[cichla81]

lookin good hulon, cant wait to see your aquascapin on that beast

 

[HULON]

The darn pump that runs the sumps is leakin all over the place had to shut it down and i am ordering a seal Oh well if thats all the trouble i have then thats a small problem so the sumps are just there lookin pretty right now not worken Thats why the heaters are up there ....

 

[jcardona1]

Hoser you are the prince of wise ARSE but i love it

Haha I am? I didn't even know I was being one