Hi all!! Been spending good 20+ hours researching this topic. I bought a square acrylic tank second hand. Dimensions 36x36x25H - 1/2 inch thickness. I added about 15 gallons of water for water test, and tank sprang couple leaks from front and side seam at the bottom.
So I emptied tank, bought Weldon 40 , applicator and .25in bevels to fit across all bottom seams and height seams (inside tank bevels). I’m getting lost on order of things. Tank has been cleaned and dried, also using compressed air to get all material out of from all seams. Should I sand 600 grit all seams and space under bevels then Weldon 40 the bevels? Or Weldon 40 first, let dry, then add bevels ? Thank you in advance !
forgot to mention last question! Clamps, should I use ? Light pressure ?
So I emptied tank, bought Weldon 40 , applicator and .25in bevels to fit across all bottom seams and height seams (inside tank bevels). I’m getting lost on order of things. Tank has been cleaned and dried, also using compressed air to get all material out of from all seams. Should I sand 600 grit all seams and space under bevels then Weldon 40 the bevels? Or Weldon 40 first, let dry, then add bevels ? Thank you in advance !
forgot to mention last question! Clamps, should I use ? Light pressure ?
Last edited: