Well I bought the foam for my 480 gallon acrylic yesterday. The foam is 1" thick and I'm wondering if this is going to be a problem or if that is a good thickness. I was going to buy 1/2" but this was the thinnest they had in 8x4 sheets.
The second problem is that the foam is basically two 1/2" 8x4 sheets glued together and are offset from one another. How do I go about fixing this as there is a 1" gap due to the offset.
My options:
Cut the overhang off and put it in the areas that need it
Somehow cut the two sheets apart and just use one 1/2" sheet
Or take this sheet back and buy two 8x2 sheets of 1/2" or a different thickness
I guess I should mention the footprint of my tank is 8x4
The second problem is that the foam is basically two 1/2" 8x4 sheets glued together and are offset from one another. How do I go about fixing this as there is a 1" gap due to the offset.
My options:
Cut the overhang off and put it in the areas that need it
Somehow cut the two sheets apart and just use one 1/2" sheet
Or take this sheet back and buy two 8x2 sheets of 1/2" or a different thickness
I guess I should mention the footprint of my tank is 8x4