I'm curious to know why you have 2 pumps, but then dialing them both back?
I never need to adjust, I just run 1 pump and only dial influent to the back to the tank, if its too much for the capacity of the overflow.
In this way(except for evaporation, or water changes) the sump stays constant.
Also, I do not shut a line down to clean filter socks, just pull the sock off, rinse and slide back on the effluent pipe.
I never need to adjust, I just run 1 pump and only dial influent to the back to the tank, if its too much for the capacity of the overflow.
In this way(except for evaporation, or water changes) the sump stays constant.
Also, I do not shut a line down to clean filter socks, just pull the sock off, rinse and slide back on the effluent pipe.