Heat Lamp Damage Silicone?

  • We are currently upgrading MFK. thanks! -neo

clemsonguy1125

Jack Dempsey
MFK Member
Sep 27, 2010
544
0
31
East Coast USA
I had bearded dragon in a 40 breeder for about a year. I recently moved him to a larger enclosure. Is it safe to use it as an aquarium again or will the heat lamps have damage the silicone seals.
Thanks
 
I had bearded dragon in a 40 breeder for about a year. I recently moved him to a larger enclosure. Is it safe to use it as an aquarium again or will the heat lamps have damage the silicone seals.
Thanks


Shouldn't, feel them and inspect them, if their not dry or cracking their fine, u can always test full outside with a hose.


Go S. Vettel #1 rb8
 
Shouldn't, feel them and inspect them, if their not dry or cracking their fine, u can always test full outside with a hose.


Go S. Vettel #1 rb8

Hello; I agree with this. One of the properties of silicone can be heat resistance. I have used silicone tubing made to repair corroded metal emissions tubing that was fitted directly to hot auto manifolds. But it does deserve some testing to be sure. I imagine there are various grades of silicone as in all things
 
Hello; I agree with this. One of the properties of silicone can be heat resistance. I have used silicone tubing made to repair corroded metal emissions tubing that was fitted directly to hot auto manifolds. But it does deserve some testing to be sure. I imagine there are various grades of silicone as in all things


Wow that's temps in excess of 400+F


Go S. Vettel #1 rb8
 
Probably fine, I'd do a fill test outside to be safe.


Sent from my iPhone using MonsterAquariaNetwork app

+1 . Ill check for cracks in the bottom first. When I had my breaded dragon in my old 55 it tried to dig and scratched at the silicone. When I used it for fish . I cut off the bad parts that were real bad and resiliconed those spots. And just covered with silicone the spots that weren't too bad. But even all scratched up the silicone still held water and the water pressure.

Sent from my Comet using MonsterAquariaNetwork App
 
Wow that's temps in excess of 400+F


Go S. Vettel #1 rb8

Hello; Yes, it was an 89 ford pickup. A small metal tube that fastened to the exaust manifold had corroded were it attached about a foot or so from the engine near the transmission. The tube was a factory only part and a bit costly. My parts house friend suggested the silicone repair tube. It attached to a nipple on the main manifold and I cut away the corroded section. Must have been a common problem. I was not sure but it was not expensive and as it was my own truck I could get the metal replacement later if needed. It was still in place a few years later when the truck was in a total wreck.
 
MonsterFishKeepers.com