Okay so my co2 has been leaking, basically it went down to 1000psi in about 6 months (normal) but since then (6 weeks) it has dropped to 400psi, I attributed it to my solenoid having aluminum threads/block and my regulator fittings being brass and the fact that the Teflon tape likely gave way, so tonight I took everything apart and re sealed but over tightened a brass fitting that goes into the aluminum solenoid threads and stripped them! I could get it 60% tight before it would give way (with 0 psi) so I put a ton of Teflon tape on the male thread and tightened it as much as I could and re arranged that side to where it would go into the bubble counter instead of holding the pressure when the solenoid clicks off.
Thinking of ordering a new one or using a product like epoxy or soldiering it so that it holds a seal but this all depends in if it doesn't leak.
Any advice.?
×Go S. Vettel #1 Infiniti Redbull! 4x WDC!!! Congrats on another flawless title× <GET BETTER SCHUMI>
__________________________________________________________________
Cheap way to decrease nitrates and keep your fish healthy: http://monsterfishkeepers.com/forums/showthread.php?t=504763
Thinking of ordering a new one or using a product like epoxy or soldiering it so that it holds a seal but this all depends in if it doesn't leak.
Any advice.?
×Go S. Vettel #1 Infiniti Redbull! 4x WDC!!! Congrats on another flawless title× <GET BETTER SCHUMI>
__________________________________________________________________
Cheap way to decrease nitrates and keep your fish healthy: http://monsterfishkeepers.com/forums/showthread.php?t=504763