Hey guys. So, as some of you may know, I cracked the bottom panel of my recently bought 240Gal tank.
I need your opinions guys on fixing it. The tanks is built with 3 pieces; the front and sides is one whole piece, the back panel, and the bottom panel.
The front and back are 20mm so I'm assuming that the bottom one is also 20mm. (I don't know why I always thought that 10mm is too thick)
The crack runs from the left side of the tank to about the middle of the tank. It branches into 3 cracks forming a fork (if that helps anything)
The tank has these bottom supports around the perimeter and one in the middle. All the supports are intact, the crack just slipped under them. They could be reused.
Also the front and back are intact.
So what are my options?
Acrylic bottom panel?
Glass? What thickness?
Plywood?
Patching?...
Anything?..
I really need your opinions guys, you are the experts.
I need your opinions guys on fixing it. The tanks is built with 3 pieces; the front and sides is one whole piece, the back panel, and the bottom panel.
The front and back are 20mm so I'm assuming that the bottom one is also 20mm. (I don't know why I always thought that 10mm is too thick)

The crack runs from the left side of the tank to about the middle of the tank. It branches into 3 cracks forming a fork (if that helps anything)

The tank has these bottom supports around the perimeter and one in the middle. All the supports are intact, the crack just slipped under them. They could be reused.
Also the front and back are intact.


So what are my options?
Acrylic bottom panel?
Glass? What thickness?
Plywood?
Patching?...
Anything?..
I really need your opinions guys, you are the experts.