Some of you may have seen my other post where I started a tank and then I ended up tearing it down to build a new one. So I worked a few hours in my basement today and this is what I got done.
The electrical outlet where the hole is in the wall was relocated to the other side of the wall (next room) and filled with insulation.
I used an excessive amount of screws, nails, and Titebond II wood glue. I know it's over kill but I wanted this thing to be heavy duty.
I am not sure if I am going with glass or acrylic yet. The window will be 86"x 30". I would like to have the top of the tank with no bracing going across so it's just glass. Water is only going to cover the glass 25" because I am not filling it up to the top.
The electrical outlet where the hole is in the wall was relocated to the other side of the wall (next room) and filled with insulation.
I used an excessive amount of screws, nails, and Titebond II wood glue. I know it's over kill but I wanted this thing to be heavy duty.
I am not sure if I am going with glass or acrylic yet. The window will be 86"x 30". I would like to have the top of the tank with no bracing going across so it's just glass. Water is only going to cover the glass 25" because I am not filling it up to the top.
