First off, sorry I didnt get any pictures while I was building the stand, just after it was finished. So if you have any questions on it, please just ask!
I made the stand a total of 30" height which includes the styrafoam. The frame was made of 2"x4"s. I used 3/4" plywood for the inside, top, back and ends of the stand. I also made the end plywood pieces so that I could remove them to be able to put in or take out my wet/dry. I made the doors as well cause buying them would have been too expensive. The center door is Red pine, the next two out are White pine, and the two end doors are Spruce.
I made the stand a total of 30" height which includes the styrafoam. The frame was made of 2"x4"s. I used 3/4" plywood for the inside, top, back and ends of the stand. I also made the end plywood pieces so that I could remove them to be able to put in or take out my wet/dry. I made the doors as well cause buying them would have been too expensive. The center door is Red pine, the next two out are White pine, and the two end doors are Spruce.
just wondering... are you going to open the back? if you're using a wet/dry i would suggest you open the back part to avoid moisture accumulation in it. nice job! what stain are you planning to use...if you would stain it though..looks good natural!
