600 gallon acrylic tear down and rebuild or roll the dice?

  • We are currently upgrading MFK. thanks! -neo
bluehand said:
Picking up my bracing tomorrow after work so hopefully will be water testing again this weekend. I assume that a butt weld would be plenty strong enough to hold lids if I did something like this in a few different spots?

View attachment 1546951

View attachment 1546952
Click to expand...

Yup 💀🤙… pretty smart solution… twin wall poly carb is prob the best choice for lids (green house panels)… super light and does not bow. Comes in a few different thicknesses. I think mine is around 3/8”. Most hardware stores carry it now. Regular 1/4” poly carb is pretty good also but bows a bit more than the twin wall at double the price. If u go with acrylic ull have to continually flip it over every so often as it bows pretty bad.
 
  • Like
Reactions: Bizdaddy
  • Like
Reactions: bluehand and wednesday13
  • Like
Reactions: bluehand
When I was trying to square out the rounded part of the patch job on top I noticed that it heated the crappy weld that was on it enough that it pretty much let loose so no I am going to try to make it look a bit better. Bonus if you ask me lol

IMG_20240809_192411194.jpg

IMG_20240809_192404215_HDR.jpg
 
  • Like
Reactions: wednesday13
  • Like
  • Haha
Reactions: danotaylor, deeda and bluehand
You must log in or register to reply here.
MonsterFishKeepers.com
Top Bottom