Dry Goods Stocklist - 03/03/2010 - PU Only

[Pharaoh]

I'm really tempted for that reeflo, except that its about twice the gph I need...

If you are still building the plywood tank, this is the pump for you.

 

[Conner]

If you are still building the plywood tank, this is the pump for you.

I figure I'll have to build it sometime in the future, but for right now I've just got the 220g, and that's WAY too much flow for it.

 

[Pharaoh]

You could always restrict it, or use some of it to push an ugj system. I was think I would eventually need a couple darts(3600gph) for my 500.

 

[Pharaoh]

BUMP-O

 

[Pharaoh]

TTT

 

[Pharaoh]

TTT

 

[polish]

What are the dimensions of the lids for the 125g? I may be able to use them on the 200g cutouts.

 

[Pharaoh]

I will say they are roughly 36" x 18". They will be a bit shorter, but that should be close enough for a ballpark. I'll measure them when I get a chance.

 

[polish]

Sounds good, no rush. Not sure when I'd be in Indy next anyway. However I've been wanting to replace the ghetto lids I have on it now with something nicer for a while. I need to check the exact cutout size too.

I know a 20g long glass lid is about 2" to short on length and a few inches short on depth. So it's likely 32" x 15" or so...

 

[Pharaoh]

OK.... actual measurements are 35" long x 14 3/4" deep (17 3/4 with additional plastic - uncut)