My green house for fish

  • We are currently upgrading MFK. thanks! -neo
The next day, after the structure was well dryed, I started the work.

At first place I covered the iron, where it would fit the structure, with small strips of polycarbonate, to maintain the maximum temperature. Like a box.
DSC04720.jpg

DSC04722.jpg


Then I cuted some more irons to help holding the structure in place, since i didn't knew the total weight of the all structure working.
DSC04726.jpg


The assembly
DSC04727.jpg

DSC04729.jpg

DSC04730.jpg

DSC04735.jpg


and the first test to see if everything worked and there were no leaks :)
DSC04736.jpg

DSC04738.jpg


You don't imagine the work. It was an incredible job. A terrible heat, close to 50°C and the arms always in the air. If it wasn't the help from my dad and wife, I don't think I could finish it.

Then the placement of policarbonate blates underneath the structure, to keep the more heat as possible. Another dificult work.
DSC04741.jpg

DSC04746.jpg

DSC04752.jpg

DSC04753.jpg


A couple of holes for the hoses
DSC04756.jpg


and the work completed before lunch
DSC04760.jpg

DSC04761.jpg


The good thing was the cod done by my mother for lunch, eheheh. Regain all the energies into a afternoon of hard labor.
 
Now values of the tests:
- Temperature outside - 20°C
- Temperature inside the GreenHouse - 36°C
- Temperature in the heating box - 55°C :eek:
- Water temperature in the tank, at the bottom - 25ºC
- Water temperature on the output of the heating system 30°C
DSC04772.jpg


Conclusions
- The system works nicely
- The pump do 2500Lt/hour. I should try, in order to heat the water even more, putting a tap on the exit to strangle the flow, making it slower.

Now, only with the completion of all operating tests, I can tune the system.
 
man that heating system is an insane idea!!!! so, have I got this right, the tubes in the roof have water running through them and are heated by the sun?
 
What do you think about this:

Is the same thing heating 2ºCx100l or 20ºCx10l!!!

If this is correct, is better to leave the heating system as it is. Because if I reduce the flow rate the water is even more heated and that hot water can damage plants, fishes and bacteria if it’s to hot.

What do you think about this?

A little help please.
 
“"Is the same thing heating 2ºCx100l or 20ºCx10l!!!”

Generally yes. There would be an optimum flow rate for maximum heat intake but the health of the fishes and plants would out weigh the small benefit.
 
MonsterFishKeepers.com