please help

[Lucifer_420]

Sounds like tour tank builder isnt so good. Id take it up with him in all honesty. Sounds like something wasnt done right.

I took this matter to him. He came over opened the whole tank and made it again. The tanks is made from 12mm toughen glass sticked with aquarium silicon.

 

[Lucifer_420]

Sounds like tour tank builder isnt so good. Id take it up with him in all honesty. Sounds like something wasnt done right.

I took this matter to him. He came over opened the whole tank and made it again. The tanks is made from 12mm toughen glass sticked with aquarium silicon.

 

[Lucifer_420]

Here are a few photos of the tank. Any op is appreciated. Thanks

 

[Backfromthedead]

So here I'm with my new tank. Dimensions 8l 2b 2.5h. So after setting the tank and adding the fishes one night suddenly BOOM!! There is water everywhere all the fishes out.the tank broke open from one side. Before this incident the tank was running just fine then to circulate the water and have a good flow rate in the tank i installed 2 wave makers ( approx 2000l per hour flow rate) is it because of the wave makers the pressure in the tank increased? Or the tank is week? After this i patched up the tank with some silicon. And again BOOM!!!!!!! same thing. What can i do now ?

Sounds like either poor quality job by the tank builder or tank was not level on stand. Maybe both.

Your tank should definitely be able to handle the wavemakers, unless of course it was not level. If the tank was overloaded to one side any sloshing could potentially amplify the problem.