Hello,
I have a 400 gallon peninsula tank that I'm setting up for mbuna. I want to use all three 1 3/4" holes as drains into the 72" Tideline sump. I will be running two jebao pumps (20,000 & 18,000). I want to run them over the side towards the opposite end of the overflow. I will also be running at least one SPC-180 wavemaker. This will only be my second sump. The first was a total DIY with soft plumbing only. I don't care what plumbing I use. I have four complete Aqueon Megaflow kits to start with. I don't care what type of plumbing I use, I just want to flow a lot of water and be able to change things once it's running and I figure out some stuff. Also, I will be running four small sand filters that I want to run with the return pumps off of a small manifold. Each is rated for about 150-gallon tank.
Thanks in advance and I'm sure I'll have lots of questions as we go.
Here are some pics to help.
I have a 400 gallon peninsula tank that I'm setting up for mbuna. I want to use all three 1 3/4" holes as drains into the 72" Tideline sump. I will be running two jebao pumps (20,000 & 18,000). I want to run them over the side towards the opposite end of the overflow. I will also be running at least one SPC-180 wavemaker. This will only be my second sump. The first was a total DIY with soft plumbing only. I don't care what plumbing I use. I have four complete Aqueon Megaflow kits to start with. I don't care what type of plumbing I use, I just want to flow a lot of water and be able to change things once it's running and I figure out some stuff. Also, I will be running four small sand filters that I want to run with the return pumps off of a small manifold. Each is rated for about 150-gallon tank.
Thanks in advance and I'm sure I'll have lots of questions as we go.
Here are some pics to help.
