Sounds good, I went to lowes today and got all supplies, beside couldn't find a check valve at lowes that was small enough so still have to go to mijer or something for that, i will post pics when i'm all done thx for all the info once again
made my Denitrater posted pics on my sump thread Here http://www.monsterfishkeepers.com/forums/showthread.php?t=158363&page=2
system builds alot of pressure I was not expecting the pressure it builds when its on slow drip, so I fixed the pin hole leaks and will give it another test run today..thx again.
the best idea is to use a valve on the intake side of the denitrator so there is little to no pressure in the system. If you regulate flow on the out feed side you can get over pressurization and blow the unit open. I have read in another forum about these units and they recommended the use of a meter to control to flow into the unit. Will look and post a link if ok with mods to the other forum.
Starting Up, wow great website with lots of info there, thx for pointing out i should use ball valve on intake side that totally makes sense, again good find on that website.