400g Systems - Looking for Input

[kendragon]

More expensive because 57W is considered a high output lamp.
You're not going to get 90mJ/cm^2 . More like 58mJ/cm^2 which in my opinion is a good fit.

 

[dr exum]

More expensive because 57W is considered a high output lamp.
You're not going to get 90mJ/cm^2 . More like 58mJ/cm^2 which in my opinion is a good fit.

should i slow the flow a bit? total system water volume 400g (exterior ) probably 300g of water -

 

[kendragon]

should i slow the flow a bit? total system water volume 400g (exterior ) probably 300g of water -

Won't change the overall UV dosage. You're recirculating the same tank water over and over again.

 

[dr exum]

got one side UV done today - need more 3/4” hose -

Aqua UV sent out some swag ?

this was not intended location - was going to put where power strip cluster is .... but.... so many wires ?

 

[The Masked Shadow]

Oh my gosh! Look at all those wires! I have been following along almost the whole time.

 

[dr exum]

Oh my gosh! Look at all those wires! I have been following along almost the whole time.

thankfully i did a few years installing hifi/wifi/ and low voltage- lots of practice with zip ties....

pretty much done - think i may have over done it for tanks that will most likely be lightly stocked ?

gotta run a hot water line vs 30amp circuit
mount battery back up
get water tubing for auto W/C

thanks all for comments / input!

 

[Backfromthedead]

That's what I'm talking about. Those stands are absolutely stuffed. Great job with the builds doc.