Cracking Acrylic aquarium

[JK47]

Yes. See the picture. Basically pick up a few of those and use Weldon 4 to add them along all the seams. Make sure you buy the 90/45/45 degree triangles so they weld in flush

View attachment 1299038

Is that extruded? Ive wondered if extruded is ok to use in corners like this

 

[Lepisosteus]

Is that extruded? Ive wondered if extruded is ok to use in corners like this

That pic was of extruded I just got it off internet. They make cast like that as well

 

[crawdaddy905]

Yes. See the picture. Basically pick up a few of those and use Weldon 4 to add them along all the seams. Make sure you buy the 90/45/45 degree triangles so they weld in flush

View attachment 1299038

I've looked all over the web and can't find what's pictured.

 

[Lepisosteus]

Have you found the square rods? They work as well. I only suggest angle cut as they sit flush.

 

[Lepisosteus]

It’s very easy to make them if you have a table saw

 

[gmaniac]

I am looking to do the same, found these if you anyone is also looking to reinforce their corners

"24196" | U.S. Plastic Corp.

www.usplastic.com