I am finishing the setup of my 180 gallon tank. I have everything all ready to go and the tank filled but have one small leak. Where the pump is connected to the sump, I am getting a small leak.
At first I tried to put a rubber seal (gasket?) on the water side of the pump (that's how the old owner had it setup) and that didn't work. So I put one on both sides and it almost worked but it still leaks very slowly.
I've had people advise against using silicone or any other sealant but I'm running out of options. Should I find a way to tighten it down more? Any ideas?
At first I tried to put a rubber seal (gasket?) on the water side of the pump (that's how the old owner had it setup) and that didn't work. So I put one on both sides and it almost worked but it still leaks very slowly.
I've had people advise against using silicone or any other sealant but I'm running out of options. Should I find a way to tighten it down more? Any ideas?
