If you really don't want to replace that sand, and I don't blame you at that price, you can angle the intakes so that they are further from the sand.
Well I was debating taking a good section out of each intake pipe with a pair of pvc cutters and raise it a good 4 inches or so. Like almost to the top 1/4 ish of the tank. Not sure if that's a bad idea though? I of course do weekly or sometimes more water changes and vacuumingIf you really don't want to replace that sand, and I don't blame you at that price, you can angle the intakes so that they are further from the sand.
Yeah, depending on high you raise them you might not be able to keep them running if you do a large water change. You can always shut them down before they break siphon and continue your water change and then turn them back on once the tank is filled enough.Well I was debating taking a good section out of each intake pipe with a pair of pvc cutters and raise it a good 4 inches or so. Like almost to the top 1/4 ish of the tank. Not sure if that's a bad idea though? I of course do weekly or sometimes more water changes and vacuuming
I think I'm just going to raise them a good amount. And I always shut down my filters and heaters when doing a water change. Dont want to chance killing any BB.Yeah, depending on high you raise them you might not be able to keep them running if you do a large water change. You can always shut them down before they break siphon and continue your water change and then turn them back on once the tank is filled enough.
You have a few avenues to take, let us know what you decide.
I use this exact substrate "sand". I chosed it for the color and since it wasn't fine compared to others I've seen.
Hi you could use some tiles , kitchen wall or floor good colours available maulm tends to settle in the gaps and hovers greatCome to think of it.....what if I go bare bottom....I've never tried it before....but I've heard it's easier to keep clean....only issue is. Is I dont want to drain and flip it over to paint the bottom of the tank. Is there another idea/option if I were to go bare????
Hi out puts will be pushing sand into the inputs with this setup I would be inclined to close up the out taps a little I know the power of the fx6Here is a couple pictures of the intakes and outtakes to maybe give you a little better of an idea of what I should do. I honestly like the look of the sand and it all costed me like 250$ to fill that tank. But I also dont want to ruin the canister. Hopefully pictures help you. I'm home from work now so if you need anything else can always ask and maybe help walk me through it if you dont mind
View attachment 1409627
View attachment 1409628