New Build ~ 600 Gallon
- Thread starter JK47
- Start date
Was just reading through your thread yet again. Holy crap has the plumbing you done intimidated the hell out of me. Not sure I can do it.
You have any videos of the setup. Can't believe how clean the bottom is. Also, I was looking to see how obvious your drains are and amazed how hard it is to spot them with the black on black theme.
You have any videos of the setup. Can't believe how clean the bottom is. Also, I was looking to see how obvious your drains are and amazed how hard it is to spot them with the black on black theme.
Any chance you can get a lot of light on the tank for a vid? I wanna see the lei under a bunch of 10ks or something.
I’ll get a video figured out and posted soon. I don’t think I’ve ever posted one here before. This is both LED over center
The plumbing on the Ultimas is not nearly as bad as it seems. Keep in mind everything is doubled up so it’s a bit misleading in regard to complexity. Anything closed loop is pretty easy.
The project I switched to was much harder to plan.. It’s almost done so I’ll get back to finishing this setup soon
I have been going through the pages specific to your drip. Did you ever create a separate thread on your drip? Mainly I am curious about convertng my cold water drip to a hot water drip like yours. Considering you are running hot water from your water heater, do you think that puts a lot of extra strain on the hot water heater? I dont want to half the life of my hot water heater.
Also, how do you get the right mix of hot/cold water to get a temperate at 77 degrees or whatever you want? Does the mixing valve take care of that or do you need to sort that out?
Also, how do you get the right mix of hot/cold water to get a temperate at 77 degrees or whatever you want? Does the mixing valve take care of that or do you need to sort that out?
I have not created a separate thread yet. Still doing finishing work in the room. The setup mounted to the wall, insulated, rocked and painted etc.. but I still need to clean up the lines. It wasn't too hard on my hot water heater and mine is old. The thermostatic mixing valve has a wheel on top. Set it and forget it type thing. Super easy
